Its 20+ years old and needs to be re-built. I was going to send it to Carver Repair for about a $300. upgrade/update but decided to buy something else for alot more money. It works fine until you start pushing it real hard and it shuts itself down for a few seconds then works fine until its drive it real hard again.
Please understand that it should be sent in for updates/upgrades. I don't want any question about it after the sale. I'd perfer the buyer test it out prior to paying for it. If you are local to the NJ area you can come by and pick it up and pay me later. If your not local drop me a PM and maybe we can work something out.
Here is a link to the only service center to send it to
Polk SDA SRSII's with upgraded x-overs - Sonicaps and Mills Resistors in the High Pass Daytons in the Low Pass also upgraded Polk RDO-194 Tweeters Dynamat applied to driver and passive radiator baskets Mye Sound Spikes
Polk SDA 2a's with upgraded x-overs (Obbligato caps and Mills resistors) RDO-194's
Anthem PRE2L tube pre-amp w/Mullard and Mazda tubes DynamiCaps
Belles 350a amp
MIT S3 IC's
Audioquest Mammoth speaker cables
Signal Cable power cords