PM700 Schematic request

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
User avatar
IFixAudio
Newbie
Posts: 2
Joined: Thu Jul 29, 2010 6:16 pm

PM700 Schematic request

Post by IFixAudio » Fri May 06, 2011 10:32 pm

Hi Group,
Does anybody out there have access to a schematic for a PM 700?
It appears to be rather difficult to find.
Maybe someone has seen the problem. It stays in protect with a +40 volt offset on both channels.
Any suggestions?

Thanks

Jim

Mr. M-500t
(pair of) SILVER-7 TUBE AMPs
Posts: 6129
Joined: Fri Mar 17, 2006 10:00 pm

Re: PM700 Schematic request

Post by Mr. M-500t » Sat May 07, 2011 8:23 am

I don't know if their remotely the same but here's a link to the service manual for the PM-600/900 amps.
Lots of info about voltages and where they should be set at.
http://thecarversite.com/manuals/files- ... manual.pdf

Post Reply

Return to “CARVER Equipment Repair/Help Forum”