It is currently Sun May 01, 2016 3:05 am
If you have Carver repair questions, or can help other users with repairs, this is the place for it
(pair of) SILVER-7 TUBE AMPs
Joined: Sun Nov 30, 2008 2:10 pm
Location: Upstate South Carolina
is the ext pross loop engaged?
#1 BLACK BEAUTY's made by the man, the myth, the legend Bob Carver
CARVER: TFM-75, TFM-45(3), SD/A-490T
SUNFIRE: Tube pre
WTL Amadeus GTA+DV DRT XV-1t
2 sets of ALS'3, set of SILVERS, set of PLATS
AUDIOCONTROL: phase coupled activator
KENWOOD: BASIC M2a (2)
“Youth ages, immaturity is outgrown, ignorance can be educated, and drunkenness sobered, but stupid lasts forever.”
The only thing I'll feel......will be the RECOIL
Necronomicon Ex-Mortis....... Klaatu Barada Nikkto
"We should seek the greatest value of our action"
You mentioned that your speakers are not rated for what your amps bridged to mono can produce. That is a common misconception. You are much more likely to damage speakers by under powering them rather than over powering them. One thing though about bridged amps, they do not like to see less than a nominal 8 ohm load, so if your speakers are 4 ohm, do not use your amps bridged.
A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
In a recent press conference, President Obama remarked, "If I had a city, it would look just like Detroit."
Who is online
Users browsing this forum: No registered users and 3 guests