Help w/ M 400 parts identification

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
Posts: 2
Joined: Sun Feb 08, 2004 5:49 pm

Help w/ M 400 parts identification

Post by cgallery » Sun Feb 08, 2004 6:02 pm

I have an M 400 that I received with a broken speaker spring connector. A friend has graciously laser-cut a piece of aluminum that holds four banana jacks (the spacing is .5" rather than .75", due to the small size of the original). But I need to find out what parts were connected to the original output strip, seen here:


It looks like two identical caps and two identical resistors. Can someone tell me the correct values and types, and (bonus) provide parts #'s from someone like Mouser? I've been stalled on this project for a while because I'm too stupid to figure out what these parts are.


Post Reply

Return to “CARVER Equipment Repair/Help Forum”