It is currently Sat May 25, 2013 10:42 pm
Carver PM350
3 posts
• Page 1 of 1
Mon Jul 16, 2012 3:19 pm
Re: Carver PM350
techster wrote:Does anyone have a schematic for the PM350? Thanks
Try looking here: http://thecarversite.com/
Its under the Carver Professional section and there is an owners manual, but no service manual that I see.
"Beauty is in the eye of the Beholder, Music is in the ear of the Listener" - ME
"Arguing cables is like arguing religion. You are likely never going to change anyone's mind, and it is not much fun if you are sober" - nwohlford
"You were on my Ignore List, but you are too damn entertaining, like a circus monkey, so I took you off" - H9
"We shouldn't laugh at people like you, we should pray for them. You have my prayers for a speedy rehabilitation you sad, silly little man" - Jstas
"Arguing cables is like arguing religion. You are likely never going to change anyone's mind, and it is not much fun if you are sober" - nwohlford
"You were on my Ignore List, but you are too damn entertaining, like a circus monkey, so I took you off" - H9
"We shouldn't laugh at people like you, we should pray for them. You have my prayers for a speedy rehabilitation you sad, silly little man" - Jstas
Mon Jul 16, 2012 3:27 pm
Re: Carver PM350
Yes, I've been there. The owners manual does not contain the schematic. Thanks anyways.
3 posts
• Page 1 of 1
Return to CARVER Equipment Repair/Help Forum
Who is online
Users browsing this forum: No registered users and 1 guest