Possible replacement woofers for Carver Amazings

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
brentslone
Newbie
Posts: 26
Joined: Mon Feb 16, 2004 9:26 am
Location: Atlanta, GA

Possible replacement woofers for Carver Amazings

Post by brentslone » Tue Mar 02, 2004 8:34 pm

Has anyone tried the Dynavox 12" dipole woofers as a replacement for the original Tonegen woofers? They have a driver, the WP-1220, that has very similar specs to the originals. They also have a driver, the SW-1220FL, that looks very similar to those used in a big-buck Carver knock-off (you know the one).

User avatar
F1nut
SILVER-7 TUBE AMP
Posts: 4491
Joined: Tue Nov 11, 2003 3:31 am
Location: The Mars Hotel

Post by F1nut » Tue Mar 02, 2004 11:59 pm

Interesting, do you have a link?
Political Correctness...defined

A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.



In a recent press conference, President Obama remarked, "If I had a city, it would look just like Detroit."

brentslone
Newbie
Posts: 26
Joined: Mon Feb 16, 2004 9:26 am
Location: Atlanta, GA

Address for Dynavox

Post by brentslone » Wed Mar 03, 2004 8:37 am

Go to http://www.dynavox.com , click link to speakers, then woofers 12".

User avatar
F1nut
SILVER-7 TUBE AMP
Posts: 4491
Joined: Tue Nov 11, 2003 3:31 am
Location: The Mars Hotel

Post by F1nut » Wed Mar 03, 2004 10:33 am

Hey, thanks!

I caught your post on Audiogon and checked them out, they do look very close, good find.
Political Correctness...defined

A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.



In a recent press conference, President Obama remarked, "If I had a city, it would look just like Detroit."

Post Reply

Return to “CARVER Equipment Repair/Help Forum”