CT-17 jumpers

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
packratt
M-400t CUBE
Posts: 146
Joined: Sat Jun 25, 2005 10:00 pm

CT-17 jumpers

Post by packratt » Sun Apr 20, 2014 10:31 pm

Swapping a CT-17 and TFM-15 into my system so I can loan my brother my HT-895 while his receiver is in the shop.

The previous owner of the CT-17 removed the jumpers for the external processor loop. Where do yall get very short RCA cords to connect components or to use in place of these jumpers? Kinda rediculous to use a 3' patch cord in place of a 1/2" jumper.
Top
User avatar
frenchguy
SILVER-7 TUBE AMP
Posts: 2726
Joined: Fri May 14, 2010 11:53 pm
Location: wisconsin

Re: CT-17 jumpers

Post by frenchguy » Sun Apr 20, 2014 11:28 pm

Well you could go get a nice peice of solid copper from the local hardware store, and cut and bend it in a nice loop to fit!! would'nt cost you much either! :)
Carver Silver 7t mono blocks, Carver M-4.0t & 2 tfm 42,s. ct-6 & ct-17, sda390t,TX11 tuner, jolida jd 100A. JBL L96 & JBL 4401,s W/Ribbon Tweeters, Dared SL-2000A tube preamp, Dared MP-5BT Integrated vacuum tube amp, 2 sets of Carver Amazing Silver speakers, oak & black. Carver Cinema 5.1 subwoofer & Tesla audio Carverfest satellite ribbon speakers & stands & Douglas connection cables
Top
packratt
M-400t CUBE
Posts: 146
Joined: Sat Jun 25, 2005 10:00 pm

Re: CT-17 jumpers

Post by packratt » Mon Apr 21, 2014 9:03 pm

so it only needs to connect the positive side. not both?
Top
Post Reply

Return to “CARVER Equipment Repair/Help Forum”