I Changed 4- 10 ohm resistors on Carver TFM35

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
Posts: 19
Joined: Sat Mar 13, 2004 12:49 pm
Location: Danville Ky

I Changed 4- 10 ohm resistors on Carver TFM35

Post by epilespaul » Mon May 03, 2004 9:12 pm

OK.... So Far Ive Changed 4 -10 ohm resistors that were checking @10k,
and have one channel working flawlessly =D> Ive narrowed the left channel down to the main input board on the rear of the unit ..there are three NJM4565LD audio output op amps the one for the left channel is checking bad... Ive ordered all three IC's ...All voltages on the main board are rock solid for the three different supply lines, all finals are good
Hope this fixes the amp ,, wish me luck see ya , epilespaul


Post by George » Tue May 04, 2004 8:25 pm

Get it on man! You get that up and running, I'm sending you my spare M-500t.

Post Reply

Return to “CARVER Equipment Repair/Help Forum”