TFM-6C

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
JimC
Newbie
Posts: 3
Joined: Sun Aug 03, 2008 8:58 pm

TFM-6C

Post by JimC » Sun Aug 03, 2008 9:15 pm

Not many posts and not sure if even worth fixing. The transient delay circuitry on my TFM6C was acting up (making noise before switching on) and finally died. No service manuals posted. If no ideas, it may be available to a good home for parts.

Thanks,
JimC

User avatar
engtaz
"TAZ"
Posts: 5399
Joined: Sat Jun 30, 2007 1:43 pm
Location: Tampa, FL

Re: TFM-6C

Post by engtaz » Mon Aug 04, 2008 4:33 am

Welcome JimC, I hope someone has some ideas for you.
engtaz


Carver M4.0T in front channels to Caver AL VI's in SACD & 2 Channel setup
C 16, PT 2400, Slim Device, Carver TX-8, 490T and Rega TT w Grado Gold cart in the 2 channel setup
Bogen SRB20 is computer amp
Carver PM-350 donated for youth church use

User avatar
snarffydoggy
SILVER-7t
Posts: 1045
Joined: Tue Feb 12, 2008 7:29 pm
Location: Fairhope, Alabama

Re: TFM-6C

Post by snarffydoggy » Mon Aug 04, 2008 7:07 am

Welcome JimC. some body with more knowledge Than I will probably chime in with some Ideas of what to do, Good Luck
snarffydoggy

whell
Newbie 50+
Posts: 50
Joined: Fri Jul 15, 2005 7:34 pm
Location: Metro Detroit

Re: TFM-6C

Post by whell » Sat Aug 23, 2008 6:16 pm

You can probably find one on eaby for less than it would cost to fix.

User avatar
OBI56
SILVER-7 TUBE AMP
Posts: 4885
Joined: Sat Oct 20, 2007 12:52 am
Location: You ... OFF MY PLANET!

Re: TFM-6C

Post by OBI56 » Sat Aug 23, 2008 6:28 pm

TFM-6c and 6cbs have been going in the $75 to $140 in the past 6 months on eBay. TFM-15, 15c and 15cbs have been going for between $145 and $200. The "average" price for refurbishment/rebuild/repair is in the $180 to $300 range
Why let facts or common sense get in the way of your opinions.

JimC
Newbie
Posts: 3
Joined: Sun Aug 03, 2008 8:58 pm

Re: TFM-6C

Post by JimC » Sat Aug 23, 2008 11:07 pm

Thanks all for the feedback. If nobody wants it for parts, I guess it goes in for recycling.

JimC

Post Reply

Return to “CARVER Equipment Repair/Help Forum”