m400 fuse question

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
m400
Newbie
Posts: 2
Joined: Wed Dec 17, 2003 11:38 pm

m400 fuse question

Post by m400 » Wed Dec 17, 2003 11:44 pm

First time poster.

I have a Carver M400 which has blown it fuse. It takes a 15 amp, 32 volt fuse and the back of the amp says Line Fuse AGC15.

So I go out and finally find a 15 amp, 32 volt fuse, for automotive use admittedly, and it blows two in a row.

Any help would be graet.

Thanks,

waveform
Newbie
Posts: 7
Joined: Fri Feb 20, 2004 9:30 pm
Location: Big D
Contact:

Fuse...

Post by waveform » Fri Feb 20, 2004 10:12 pm

It has to be a SLOW BLOW type fuse! I went through this headache once with my M-500t back in the 80's. My 10 amp fuse had a white paper like cylinder for the body. A regular one will blow almost immediately, LMAO...
fuggetaboutit...

Post Reply

Return to “CARVER Equipment Repair/Help Forum”