It is currently Thu Oct 23, 2014 3:36 am
If you have Carver repair questions, or can help other users with repairs, this is the place for it
(pair of) SILVER-7 TUBE AMPs
Joined: Wed Jun 06, 2007 8:29 pm
Location: The west's most mid-western town, Scottsdale, Arizona
There is a difference between hearing and listening...
Making life enjoyable through expensive electronics.
Carver: C-4000 & C-1 preamps, PSC-60 preamp/tuner, TX-11a tuner, M-400 (2), C-500, M-500, M-500t, M-500t Mk.II, A-500x, AL-III loudspeakers (2 pr.)
Sunfire:Theater Grand III processor, Ultimate Receiver, Cinema Grand Signature 400 ~ seven, True Subwoofer Mk. II, D-10 Subwoofer
thsmith wrote:I have a TFM-55x that the right channel is weak and distorted but the left channel sounds fine. I was thinking of trying it in mono mode for my center but since the left channel works could I use my AVR pre-out for the center and run my center off just the left channel or would I cause permenant damage by not having anything connected to the right channel ?
Denpends on source of problem. Because your your amp is old, number of things can cause the problem you have. It can be dried up caps shorting circuit some where, or leaky pre, drivers or lost half of output transistors etc.. If these are the case then you can cause more damage by powering up your amp at this point. If you have to power up, you should not connect any thing to faulty channel to minimize further damages. Good luck
Who is online
Users browsing this forum: No registered users and 2 guests