It is currently Wed May 25, 2016 11:58 am
Just found us? Entering CarverAudio.com for the first time? Post your introductions here and say hi to all of the other Carver enthusiasts.
keta6atl wrote:Hi!...I'm a newb to carver amps..and this forum....so please forgive my ignorance... I recently purchased a VERY lightly used carver 806x 6 channel amp and want to bridge my front 3 channels in my Home theater system. The gent that I bought this beauty from mentioned it would be able to be bridged...BUT...I can't find any manual or help online to show me how to do this! I would appreciate ANY help...I really don't want to fry my speakers...or the amp in the process!....thx again!
Hey Rob welcome to the forum. Running a bridged 806X for my center and surrounds. PM me wtih your e-mail address and I will scan the pages on bridging and send them to you. Enjoy the amp. I was very pleased with how well it sounded. Puts out about 360 watts a channel in the bridged mode running 3 channels. FYI, be forewarned, the 806X manual states only use 8 ohm speakers.
Carver M4.0T in front channels to Caver AL VI's in SACD & 2 Channel setup
C 16, PT 2400, Slim Device, Carver TX-8, 490T and Rega TT w Grado Gold cart in the 2 channel setup
Bogen SRB20 is computer amp
Carver PM-350 donated for youth church use
Who is online
Users browsing this forum: No registered users and 5 guests