solder

Carver Home Audio (Stereo) Discussions and Questions
Post Reply
2-tall
Newbie
Posts: 37
Joined: Mon May 11, 2009 4:59 pm

solder

Post by 2-tall » Tue Dec 20, 2011 12:09 am

I have found that the binding post on my TFM55 are not making good contact to the board . This is causing the speakers to cut out.Is there any special solder to use on the board?


Thanks

User avatar
F1nut
SILVER-7 TUBE AMP
Posts: 4491
Joined: Tue Nov 11, 2003 3:31 am
Location: The Mars Hotel

Re: solder

Post by F1nut » Tue Dec 20, 2011 3:21 am

While any non-acid flux solder will do, I recommend Cardas solder.
Political Correctness...defined

A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.



In a recent press conference, President Obama remarked, "If I had a city, it would look just like Detroit."

Post Reply

Return to “Carver Home (Audio)”