It is currently Wed May 27, 2015 12:55 am
Just found us? Entering CarverAudio.com for the first time? Post your introductions here and say hi to all of the other Carver enthusiasts.
(pair of) SILVER-7 TUBE AMPs
Joined: Sun Nov 30, 2008 2:10 pm
Location: Upstate South Carolina
Yes, I worked for eight years in the Division of Engineering Services. We assisted the research efforts in the six colleges of engineering. Done a few other things since then.
I finally graduated from work and am having a blast living on the lake and traveling in our RV.
(pair of) SILVER-7 TUBE AMPs
Joined: Sun Jan 14, 2007 11:53 am
Location: TN Native Languishing in VA
From FrankieD's lips to your ears: Sunfire - a quiet box of endless power.
Sunfire TG-IV/400~7 Amp
Carver SD/A-360 CDP
Active bi-amp: Ashly XR-1001 & 2 Rane PEQ-15s
Main: HotRodded AL-IIIs
Sub: Klipsch RT-12d
Center: Sunfire CRS-3c
Surround: Sunfire CRS-3 (x 2)
OconeeOrange wrote:"Gary likes to play it 'loud' as do I. His system begs you turn it up until you die"
RIP WIlliam B. Dibble, 1948-2012. I'll miss you my friend.
I used a heat gun and went back and forth over the areas where buzing was suspected. The gun was always in motion to prevent damage from exessive heat. I knew the yellow plastic used could take a lot of heat, but not the adhesive for the metal ribbon. We used the plastic film in tape form as insulation for solenoid coils that got super hot. It is also used for voice coil forms.
Exactly how it cured the problem or what happens at the heated sites I am not sure. I read somewhere that heat solves the problem, so I tried it and it worked.
Be cautios if you try it. Do a little bit at a time and then check for the cure.
I am leaving on a trip so I won't reply for about 3 weeks if necessary.
Carver M4.0T in front channels to Caver AL VI's in SACD & 2 Channel setup
C 16, PT 2400, Slim Device, Carver TX-8, 490T and Rega TT w Grado Gold cart in the 2 channel setup
Bogen SRB20 is computer amp
Carver PM-350 donated for youth church use
Joined: Fri May 14, 2010 11:53 pm
Location: wisconsin,home of the Green Bay Packers!
Garyspang wrote:Ribbons are still working great after heat-gun treatment over three years ago. Have mounted two shorter ribbons for surround speakers in 12 inch diameter round concrete forms from LOWES. Filled with fiberglass. Works great and has same voicing as main large front ribbons.
Just a little FYI....
The way you have the ribbons mounted, they are backwards. This is putting them out of phase with your front speakers, which in turn I'm sure is causing some kind of cancelations.
Easy fix is to swap the lead wires at the amp to put them back in phase.
~You think Einstein walked around thinkin' everyone was a bunch of dumb shits?~
ＳＨＵＴ ＵＰ ＡＮＤ ＥＮＪＯＹ ＴＨＥ ＭＵＳＩＣ！
Who is online
Users browsing this forum: No registered users and 1 guest