Front end specs for an MX-130?

If you have Carver repair questions, or can help other users with repairs, this is the place for it
Post Reply
jv9999
Newbie
Posts: 4
Joined: Sun Dec 23, 2012 11:38 pm

Front end specs for an MX-130?

Post by jv9999 » Sun Dec 23, 2012 11:52 pm

I have an MX-130 that the ferrite crumbled in when I tried to adjust it (T2 in the FD219U51 front end). Anyone know where I might find the specs on it? It's not in the service manual. They treat the whole front end as one component. Thanks in advance for any tips or leads.

Post Reply

Return to “CARVER Equipment Repair/Help Forum”